What are the steps for Calibration and double checking after post Calibration of your Bio-Well device?

  1. Put calibration unit into Bio-Well, ensuring cord from calibration unit is connected to calibration unit and the back of the Bio-Well.

  2. Calibration on the left-hand column of the software.

  3. Once calibration is complete, with the calibration unit still in the device, go to your cards and select the one that you created and have dedicated to double-checking your calibration (You can put it as 1_Calibration so it is always on top)

  4. Once in the card, run a stress scan.

  5. Once the scan is done, when looking at the stress scan results, you only pay attention to the Parameters Tab and more specifically the energy. If it is between 65-70 then you are in the sweet spot range.

Tiffany Barsotti